Main Control Panel - Teledyne 980 DP1.4 User Manual

980 DP 1.4 Video Generator / Analyzer - User Guide
Network Analyzer – Dashboard Items

V Total
Third Row Items:

Res[olution]
determined from the main stream attributes.

Total (video) pixels and lines
determined from the main stream attributes.

Sync
and the number of vertical lines in the blanking and its polarity (e.g. 5 lines, positive).

Start
attributes.

Colorimetry and bit depth
attributes.

Scan - The scan type used, progressive (e.g. Prog) or interlaced (Inter) determined from the main
stream attributes.
Fourth Row Items:

Sync -Clk
synchronous. A value of N means async; a value of Y means synchronous. This value is determined by the
main stream attributes.

Stereo-3D

Mute - The AudioMute flag status determined from the main stream attributes.

HDCP-Sync
for HDCP sync not detected.

Mvid
attributes.

Nvid
attributes.

11.3 Main Control Panel

This subsection describes the main control panel for the Network Analyzer. Refer to the table below for a
description of these controls.
Network Analyzer –
Control Panel
Main Control Panel
(two views – Active /
Inactive)
Page 227
- This is the measured total vertical video lines per frame.
- The active video resolution in horizontal pixels and vertical lines
- The number of horizontal pixels in the blanking and it polarity (e.g. 44 pixels, positive)
- The starting pixel and line in the active video determined from the main stream
- Indicates if the Link Clock and Main Video Stream clock are asynchronous or
- The status of 3D audio determined from the main stream attributes.
- The HDCP sync detect of the Video Blanking VB-ID bits. Y for sync detected; No
- The Mvid value used for stream clock recovery. This is determined from the main stream
- The Nvid value used for stream clock recovery. This is determined from the main stream
Control Button Descriptions
The following controls are provided in the main control panel on the right edge of
the Real Time mode interface. Each of the buttons have a pull-down menu
associated with them. The purpose of each button and their basic control functions
are described below:
 Home – The Home button
takes you back to the home screen Apps Panel.
- The total video in horizontal pixels and vertical lines
- The colorimetry and bit depth determined from the main stream
is a navigation button that when pressed
Rev. A1
June 16, 2017