Navigating Through The 980 Gui Manager Interface - Teledyne 980 DP1.4 User Manual

980 DP 1.4 Video Generator / Analyzer - User Guide
Connection for video testing – 980R Direct Connection (Rear View)
Connection for video testing – 980R Ethernet hub or corporate LAN example (Rear View)
To make the physical DP connections:
This procedure assumes that you have assembled the 980B/980R with the 980 DP 1.4 Video Generator / Analyzer
module and the DP display device under test and applied power to all these devices. Refer to the procedures
below and the diagram above.
1. Connect your DP display device under test to one of the DP Tx connectors on the 980 DP Video Generator /
Analyzer module. Use a DP-compliant cable.
Note: The DP Video Generator module can be installed in either slot 3 (shown) or slot 6 of the 980B and slot 1,
3 or 6 in the 980R.
3.4

Navigating through the 980 GUI Manager interface

Use the following procedures to navigate to the 980 DP 1.4 Video Generator / Analyzer module testing functions.
You can access the 980 DP 1.4 Video Generator / Analyzer module functionality through the Card Control tab
(Page 1 of 4) of the Apps panel. Use the procedures provided below.
Page 21
Rev. A1
June 16, 2017