Connecting A Displayport Source To The Rx Analyzer Port - Teledyne 980 DP1.4 User Manual

980 DP 1.4 Video Generator / Analyzer - User Guide
Network Analyzer –
Control Panel

11.4 Connecting a DisplayPort source to the Rx Analyzer port

This subsection provides procedures on how to connect to the DP Rx Analyzer.
1. Connect the DP source device to the DP module's Rx Analyzer port as shown below.
Note the second PC shown is used for the 980 GUI Manager application.
Page 228
Control Button Descriptions
 Back – The Back button
takes you back to the previously viewed screen.
 Nav – The Nav button
panel where you can access various data files.
 Port – The Port button
the Rx Network Analyzer function of the 980 HDMI Video Generator module
and the Rx Real Time view of the 980 HDMI Protocol Analyzer module.
 Start/Stop –The Start / Stop button
disable the showing of the incoming video image.
 Video – The video button
shown) is used to display the Video Info panel which provides timing, resolution
and other basic information about the incoming video.
Color – The Color button
o
enables you to identify the color of any particular pixel.
Scale – The Scale button and associated dialog box enables you to set the
o
size, quality and aspect ratio of the incoming video image.

Back - The arrow button
view and the previous view.

Mode - The Mode button
980 HDMI Video Generator's Rx port.

Tools - The Tools button
Tx and Rx ports, view link training status, generate a hot plug with the
associated flyout controls and run a pseudo-random noise test on a cable:
is a navigation button that when pressed
when pressed takes you to the navigation
enables you to toggle back and forth between
/
and associated pull-down menu (not
and associated dialog box
enables you to toggle between the current
enables you to toggle HDCP on or off on the
enables you to set the EDID, configure the
Rev. A1
is used to enable and
June 16, 2017