Table of Contents
Advertisement
G
ETTING STARTED
This chapter describes names and functions of the front panel, rear
panel, and screen display and provides the basic procedures for
operating the T3LCR series.
Overview
The Teledyne T3LCR series is a general-purpose LCR meter for
incoming inspection of components, quality control, and laboratory
use.
The T3LCR series is used for evaluating LCR components,
materials, and semiconductor devices over a wide range of
frequencies (10 Hz to 300 kHz) and test signal levels (10.00mV to
2.00V & 100.0uA to 20.00mA).
With its built-in comparator, the T3LCR series can output
comparison/decision results for sorting components into a
maximum of ten bins. Furthermore, by using the handler interface,
the T3LCR
series can be easily combined with a component handler,
and a system controller to fully automate component testing,
sorting, and quality- control data processing.
The list Meas function permits entry of up to 10 frequencies or test
signal levels points to be automatically measured.
Main Features
Correction
Function
Comparator
Function
(Sorting)
• OPEN/SHORT correction
Eliminates measurement errors due to stray
parasitic impedance in the test fixtures.
• Bin sort
The primary parameter can be sorted into
BIN1- BIN9, AUX, OUT and HI/IN/LO for
each of the primary measurement parameters.
The sequential mode or tolerance mode can be
selected as the sorting mode.
3
Advertisement
Table of Contents
