Exception Settings - EverFocus EAN7360 User Manual

7.3.1.4. Exception Settings

Network Failure Detection Settings
To set up the alarm input function:
1. Check the Enable box to enable the exception function.
2. Set up event reactions for the motion detection function. Check the box of the desired
reaction (Email, Alarm output, Snapshot, Record or Audio Output) to link with the function.
Alarm Output: Check the box to enable triggering the external alarm device.

Trigger Alarm Output Duration Time: Enter the alarm output duration time (between
10 and 3600 seconds).
Alarm I/O Settings: Select Normal Open or Normal Close from the drop-down list.
Snapshot: Check the box to enable taking snapshots to the micro SD Card when an

event occurs. You can further configure the Snapshot settings including Snapshot
Interval and Snapshot No.. For example, if you set up the Snapshot Interval to 5 and
Snapshot No. to 3, system will take 3 snapshots every 5 seconds.
Record: Check the box to enable recording to the micro SD Card when an event occurs.

Audio Output: Check the box to enable triggering the audio output.

Notice PPPoE IP by Email
Enable: Check the box to enable PPPoE IP mail notification function. The IP mail notification
function enables the system to send an email notification of the PPPoE IP to the email address
66
EAN7360 / EHN7360 / EZN7360