Omron E5CN-H Communications Manual page 37

SECTION 2 CompoWay/F Communications Procedures
2-14
Error Occurred
Response code Error name
1002 Command too
short
1101 Area type error
1100 Parameter error
3003 Read-only error
2203 Operation error
Note: For details on AT (auto-tuning), refer to the separate User's
Manuals.
Cause
The command is too short.
The variable type is wrong.
• Bit position is not "00."
• The write data is out of the setting
range.
Variable type "C0" was written to.
• The Communications Writing
parameter is set to "OFF" (dis-
abled).
• Attempted to write to a parameter
in setup area 1 from setup area 0.
• Attempted to write to a protect
parameter from other than the pro-
tect level.
• AT (auto-tuning) was in progress.
(See note.)
• EEPROM error