Table of Contents
Advertisement
2.2.1.3 LED Definition
The LEDs indicate the status of 10/100 Mbps Ethernet ports, 1000Base-T ports, Temp. Fan and Power.
LED
State
System
Power
On
SNMP
On
Console
On
*1
Fan
On
*2
Temp
On
10BaseT/100BaseTX Ports
LNK
On
*3
Mode
COL
On
ACT
On
FDX
On
100M
On
1000BaseT Ports
LNK
On
ACT
On
*1 There are two 4-inch fans and one 2-inch fan in the unit. Normally, one of the 4-inch fans and
2-inch fan is running. Another 4-inch fan is standby and not working. Once one of the two
running fans is failed, the standby fan will be drove to run and the Fan LED will light on.
*2 When the internal temperature is equal to or higher than 60 degree C, the standby fan will be drove
to run and the Temp LED will light on. Once the temperature is equal to or higher than 70 degree
C, the buzzer will sound. You can press the buzzer On/Off button to turn off the buzzer.
*3 Use the Mode button to select LED display mode.
2.2.2 Front Panel of WGS3-404
The front panel of the WGS3-404 has 4 RJ-45 ports for 10/100/1000 Mbps in the middle. The port status
LEDs are indicated at the left. The expansion modules are situated at the right.
2.2.2.1 Front Panel Description
LEDs
System LEDs
10/100/1000 Mbps ports
WGS3 Layer 3 Switch User's Manual
Indication
Switch is receiving power.
SNMP agent operational.
RS-232 Console interface is operating
One of the fans is failed and standby fan is running
The internal temperature is equal to or higher than 60 degree C
Port has established a valid network connection
Collision occurs on the port
Traffic is passing through the port
Been set to full duplex
Connected on 100M speed
Port has established a valid network connection
Traffic is passing through the port
- 5 -
Expansion Ports
Advertisement
Table of Contents
