Configuring The Serial Port - Planet Networking & Communication WGS3-2620 User Manual

5.3.2 Configuring the Serial Port

If you are having difficulties making an out-of-band console connection to the serial port on the switch,
you can display or modify the current settings for the serial port through the Web agent. Click on the
serial port icon in the switch image to display or configure these settings, as shown below.
Parameter Default
Management Mode Console Mode
Baud Rate 19200
Data Bits 8 bits
Stop Bits 1 bit
Parity none
Time-Out 0 minutes
Auto Refresh 10 second
WGS3 Layer 3 Switch User's Manual
Description
Indicates that the port settings are for direct console connection.
The rate at which data is sent between devices. Options : 9600,
19200 and 38400 baud.
Sets the data bits of the RS-232 port. Options : 7, 8
Sets the stop bits of the RS-232 port. Options : 1, 2
Sets the parity of the RS-232 port. Options : none/odd/even
If no input is received from the attached device after this interval,
the current session is automatically closed. Range : 0 - 100
minutes; where 0 indicates disabled
Sets the interval before a console session will auto refresh the
console information, such as Spanning Tree Information, Port
Configuration, Port Statistics, and RMON Statistics.
Range : 0, or 5-255 seconds; where 0 indicates disabled
- 139 -