Table of Contents
Advertisement
5.6 Management Setup Menu
After initially logging onto the system, you can use this menu to configure access rights. You should set
user names and passwords (User Configuration). Remember to record them in a safe place. You should
also set the community string which controls access to the on-board SNMP agent via in-band
management software (SNMP Configuration). The items provided by the Management Setup Menu are
described in the following sections.
Menu
Network Configuration Includes IP setup * and HTTP setup for the on-board Web agent.
Serial Port
Configuration
SNMP Configuration
User Configuration
TFTP Download
Configuration File
* Only displays on WGS3-2620 when it is set to Layer 2 mode.
WGS3 Layer 3 Switch User's Manual
Description
Sets communication parameters for the serial port, including baud rate, console
time-out, and screen data refresh interval. (See "Configuring the Serial Port")
Activates authentication failure traps; and configures communities and trap
managers.
Sets the user names and passwords for system access.
Downloads new version of firmware to update your system (in-band).
Saves or restores configuration data based on the specified file.
- 145 -
Advertisement
Table of Contents
