Port Description; Led Definition; Rear Panel Of Wgs3-2620 And Wgs3-404 - Planet Networking & Communication WGS3-2620 User Manual

2.2.2.2 Port Description

Ports # of Ports
10/100/1000 4
Expansion 4
Ports

2.2.2.3 LED Definition

The LEDs indicate the status of 10/100/1000 Mbps Ethernet ports, Over Heat, Fan Failure and Power.
The LEDs are explained in the following tables.
LED
System
Power
*1
Fan Failure
*2
Over Heat
10/100/1000 Ports
Act
FDX/COL
1000
100
10
*1 There are two 4-inch fans and one 2-inch fan in the unit. Normally, one of the 4-inch fans and
2-inch fan is running. Another 4-inch fan is standby and not working. Once one of the two
running fans is failed, the standby fan will be drove to run and the Fan LED will light on.
*2 When the internal temperature is equal to or higher than 60 degree C, the standby fan will be
drove to run and the Temp LED will light on. Once the temperature is equal to or higher than 70
degree C, the buzzer will sound. You can press the buzzer On/Off button to turn off the buzzer.

2.2.3 Rear Panel of WGS3-2620 and WGS3-404

The rear panel of WGS3-2620 and WGS3-404 has a power connector, a Buzzer button and a console
port. The following picture shows their rear panel.
WGS3 Layer 3 Switch User's Manual
Description
These RJ-45 ports support network speeds of 10, 100 or 1000 Mbps,
and can operate in full-duplex modes.
These ports provide for the installation of one or two expansion
modules that establish a Fast or Gigabit Ethernet connection.
Note: You may install an 1000Base-SX or 1000Base-T expansion
module and use fiber optic or category 5 cabling.
Color Indication
Green Lights to indicate switch is receiving power.
Red Lights to indicate one of the fans is failed and standby fan is
running
Red Lights to indicate the internal temperature is equal to or higher
than 60 degree C
Green Lights to indicate the Switch is actively receiving or sending the
data over the port.
Yellow Lights green to indicate that the port is operating in full-duplex
mode.
Blinks orange periodically to indicate that the connection is
experiencing collisions.
Green Lights to indicate that the Switch is sending or receiving data at
1000 Mbps.
Green Lights to indicate that the Switch is sending or receiving data at
100 Mbps.
Yellow Lights to indicate that the Switch is sending or receiving data at
10 Mbps.
- 6 -