Configuring Ip Settings - Planet Networking & Communication WGS3-2620 User Manual

5.7.5 Configuring IP Settings

If this switch is WGS3-404 or WGS3-2620 in multilayer mode, the IP Menu will be displayed.
Use this menu to configure the IP subnets for each VLAN on your switch, the unicast and multicast
routing protocols, static ARP entries, static IP routes, and the default IP route.
Parameter
Subnet IP Subnet Configuration – Specifies the IP interface for VLANs configured on this
Configuration switch, including the subnet address and routing protocols.
Port Group Configuration – See "5.7.3.2 VLAN Table Configuration".
Protocol Configures ARP timeout, enables Proxy ARP, sets the preferred servers for
Configuration BOOTP/DHCP Relay, as well as enabling/configuring unicast and multicast protocols
globally for this switch.
Static ARP Used to map an IP address to a specific physical MAC address.
Configuration
Static Route Used to configure static routes to other IP networks, subnetworks, or hosts.
Default Route Defines the router to which this switch will forward all traffic for unknown networks.
WGS3 Layer 3 Switch User's Manual
Description
- 176 -