Table Of Contents - Genie Z-34/22 Operator's Manual

Table of Contents

Table Of Contents2
Safety Rules3
Electrocution Hazards4
Tip-Over Hazards4
Z-34/22N, Maximum Slope Rating, Stowed Position6
Z-34/22 Dc, Maximum Slope Rating, Stowed Position6
Fall Hazards8
Collision Hazards8
Component Damage Hazard9
Damaged Machine Hazards9
Bodily Injury Hazard10
Decal Legend10
Battery Safety11
Burn Hazards11
Component Damage Hazards11
Tip-Over Hazard11
Controls12
Platform Control Panel12
Ground Control Panel13
Legend14
Pre-Operation Inspection15
Fundamentals15
Maintenance17
Check The Hydraulic Oil Level17
Observe And Obey17
Maintenance Symbols Legend17
Check The Batteries18
Check The Tire Pressure18
Standard Batteries18
Scheduled Maintenance19
Function Tests20
At The Ground Controls20
Test Emergency Stop20
At The Platform Controls21
Test The Boom Functions21
Test The Tilt Sensor21
Test The Horn22
Test Machine Functions22
Test The Foot Switch22
Test The Steering22
Test Drive And Braking23
Test Limited Drive Speed23
Test The Drive Enable System24
Test The Lift/Drive Select Function24
Workplace Inspection25
Operating Instructions26
Emergency Stop27
Operation From Ground27
Auxiliary Controls27
Operation From Platform27
To Steer28
To Drive28
Driving On A Slope28
Low Voltage Interrupt29
To Determine The Slope Grade29
Drive Enable29
Machine Not Level Indicator Light30
Platform Overload Indicator Light30
Aircraft Protection Package30
Ansi, Csa And Aus Models30
Fall Protection31
After Each Use31
Battery And Charger Instructions32
Dry Battery Filling And Charging32
To Charge The Batteries32
Maintenance-Free Batteries32
Transport And Lifting Instructions33
Free-Wheel Configuration For Winching33
Securing To Truck Or Trailer For Transit34
Securing The Platform34
Securing The Chassis34
Lifting Instructions35
Decals36
Inspection For Decals With Words36
Inspection For Decals With Symbols38
Specifications40
Drive Speeds, Maximum40
Maximum Slope Rating, Stowed Position40
Floor Loading Information40
Range Of Motion42