Maintenance Table - Genie GTH-4013 sx Service Manual

May 2008
3.3

MAINTENANCE TABLE

During the first 10 working hours:
A-1 Check the oil level within reduction gears, power divider and differential gears.
A-2 Check the tightening of the wheel bolt.
A-3 Check the tightening of all bolts and nuts.
A-4 Check the couplings for oil leaks.
Every 10 working hours or daily:
A-5 Check the Operator's Manual inside the machine.
A-6 Check the labels and plates are well visible.
A-7 Check the engine oil level.
A-8 Check and clean the air suction filter.
A-9 Check and clean the radiator.
A-10 Check the hydraulic oil level in the tank.
A-11 Check the greasing of the boom section pads.
A-12 Grease the forks.
A-13 Grease all joints of the boom, the rear axle shaft joint, the transmission shafts, the front and rear axles and
any equipment of the machine.
A-14 Check the efficiency of the lighting electric system.
A-15 Check the efficiency of braking system and parking brake.
A-16 Check the efficiency of the steering selection system.
A-17 Check the efficiency of the fork balancing system.
A-18 Make sure the safety devices installed are in efficient working order.
A-19 Check the engine coolant level.
A-20 Check the efficiency of the overload system.
A-21 Check the re-sequence of the boom extenxion of the GTH 4013 SX.
Document 57.4403.4200
TABLE A
GTH-4013 SX GTH-4017 SX
Section 3 - Maintenance Inspections
MAINTENANCE INSPECTIONS
Courtesy of Crane.Market
3