Genie Z-34/22 Operator's Manual page 5

Sixth Edition • First Printing
CE and Australia Markets: Do not use air-filled
tires. These machines are equipped with
foam-filled tires. Wheel weight and proper
counterweight configuration are critical to stability.
Do not raise or extend the boom unless the
machine is on a firm, level surface.
Do not depend on the tilt alarm as a level indicator.
The tilt alarm sounds in the platform only when the
machine is on a severe slope.
If the tilt alarm sounds while the boom is lowered:
Do not extend, rotate or raise the boom above
horizontal. Move the machine to a firm, level
surface before raising the platform.
Part No. 1258814
ANSI, CSA and AUS models: If the tilt alarm
sounds when the platform is raised: Use extreme
caution. Identify the condition of the boom on the
slope as shown below. Follow the steps to lower
the boom before moving to a firm, level surface. Do
not rotate the boom while lowering.
CE models: If the tilt alarm sounds when the
platform is raised, use extreme caution. The
Machine Not Level indicator light will come on and
the drive function in one or both directions will not
operate. Identify the condition of the boom on the
slope as shown below. Follow the steps to lower
the boom before moving to a firm, level surface. Do
not rotate the boom while lowering.
All models: If the tilt alarm
sounds with the platform uphill:
1 Lower the primary boom.
2 Lower the secondary boom.
3 Retract the primary boom.
If the tilt alarm sounds with the
platform downhill:
1 Retract the primary
boom.
2 Lower the secondary
boom.
3 Lower the primary
boom.
Z-34/22 • Z-34/22N
Operator's Manual
SAFETY RULES
3
3
3