Machine Not Level Indicator Light; Platform Overload Indicator Light; Aircraft Protection Package; Ansi, Csa And Aus Models - Genie Z-34/22 Operator's Manual

Operator's Manual
OPERATING INSTRUCTIONS
Machine Not Level
Indicator Light
ANSI, CSA and AUS models: Light
on indicates the machine is not level.
The tilt alarm will be sounding when this light is on.
Identify the condition of the boom on the slope as
shown below. Follow the steps to lower the boom
before moving to a firm, level surface. Do not rotate
the boom while lowering.
CE models: If the tilt alarm sounds when the
platform is raised, the Machine Not Level indicator
light will come on and the drive function in one or
both directions will not operate. Identify the
condition of the boom on the slope as shown below.
Follow the steps to lower the boom before moving
to a firm, level surface. Do not rotate the boom
while lowering.
All models: If the tilt alarm
sounds with the platform
uphill:
1 Lower the primary boom.
2 Lower the secondary
boom.
3 Retract the primary boom.
If the tilt alarm sounds
with the platform
downhill:
1 Retract the primary
boom.
2 Lower the secondary
boom.
3 Lower the primary boom.
28
Platform Overload Indicator
Light (if equipped)

Aircraft Protection Package

(If equipped)
If the platform bumpers come into contact with
aircraft components, the machine will shut down
and no functions will operate.
1 Start the engine.
2 Press down the foot switch.
3 Move and hold the aircraft protection function
3
4 Move the appropriate function control handle or
3
Z-34/22 • Z-34/22N
Sixth Edition • First Printing
Light flashing indicates the
platform is overloaded and no
functions will operate.
Remove weight from the platform
until the light goes off.
override switch.
toggle switch to move the machine away from
aircraft components.
Part No. 1258814