Erasing Macropower & Other Macro Commands - Universal Remote Control URC-SR3 Owner's Manual

Erasing MacroPower & Other
Macro Commands
STEP 1: To erase MacroPower commands on
the POWER [ON] or [SYSTEM OFF] button,
press and hold either the POWER [ON] or
[SYSTEM OFF] button and the [MUTE] button
simultaneously for two seconds until the current
status Component light turns on.
ALL OFF
POWER ON
SELECT
5
CH
5
STEP 2: Press the CHANNEL UP [CH ]
button to erase and exit Erase mode. The
component light will blink two times to confirm
the erasure.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode,
and you will have to start over with stepone.
Page | 30