Table of Contents
Advertisement
Channel Control Punch Through
This punch through lets you set up the URC-
SR3 remote so that either the Cable or TV
Channel Controls (CHANNEL UP , DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will operate in other component
modes on the remote control.
STEP 1: Press and hold the component
button you want to add channel control to,
such as [DVD], and the SELECT [SEL] button
at the same time for two seconds until the
Component light turns on.
Release the buttons.
COMPONENT
BUTTONS
SELECT
CH
5
STEP 2: Press the CHANNEL UP [CH
] button.
The component LED light will blink once.
NOTE: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step one.
STEP 3: Press either the [TV] or CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink two times to confirm it is saved.
Page | 25
Hide quick links:
Advertisement
Table of Contents
