Erasing Macropower Commands - Universal Remote Control TOTAL CONTROL FX-1 Owner's Manual

Erasing MacroPower Commands

For erasing MacroPower commands on the POWER ON or
SYSTEM OFF button, press and hold either the POWER ON
or SYSTEM OFF button you wish to erase and the MUTE
button simultaneously for 3 seconds until the component
LED light turns on.
IMPORTANT: If you do not press a button within 20 seconds
the LED light will turn off. The remote will exit the set-up
mode and you will have to start over.
Press the Channel UP button to erase and exit the Erase
mode. The component LED light will blink three times to
confirm the erasure.
Repeat Steps 1-2 to erase MacroPower commands
from other components.
16