Simplesound™ Total System Volume Control - Universal Remote Control URC-SR3 Owner's Manual

SimpleSound ™ Total System
Volume Control Punch Through
SimpleSound gives you total volume control
over ALL the components in your system,
even those that do not have built—in volume
control, such as TIVO and DVD. It saves you
the hassle of switching between component
modes just to control volume.
STEP 1: Identify which device in your system
will be used to deliver sound. In a basic system,
the sound may come from your TV speaker. In
a more advanced system, the sound may come
from your audio components (such as a
Surround Sound Receiver or Home Theatre
system).
COMPONENT
BUTTONS
SELECT
BUTTON
STEP 2: Press and hold the button that
corresponds to the Component you want to
add volume control to (such as a DVD) and the
SELECT (SEL) button at the same time for about
three seconds until the component light turns
on. Release the buttons.
VOLUME
UP
5
STEP 3: Press the VOLUME UP [VOL ]
button and then press either the TV or AUDIO
Component button that you want touse for
volume. The Component light willblink three
times to confirm that it is saved.
This sets up three buttons (Volume Up, Volume
Down and MUTE) as a group for that component.
Repeat Steps 1-2 for all other components.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode,and you
will have to start over with step one.
Page | 24