Erasing Commands - Overview - Universal Remote Control RF30 MASTERCONTROL Owner's Manual

37
STEP 4:
Align the two RF30s head-tohead,
about an inch apart.
STEP 5:
Press the RECV display button
on the unprogrammed RF30 that
you want to setup by cloning.
STEP 6:
Press the SEND display button
on the programmed RF30 that
you want to clone.
STEP 7:
Press the START button on the
unprogrammed RF30, and then
press the START button on the
programmed RF30 that you want
to clone.
NOTE: Cloning typically takes about 40
seconds. After successful cloning is com-
pleted, the newly cloned RF30 will flash
"GOOD".
STEP 8:
Return to normal operation by
pressing the MAIN button twice.

Erasing Commands - Overview

You can erase an individual button with a learned
command, a macro or a favorite channel. You can erase an
ENTIRE Component's learned command or macro buttons.
You can also erase ALL your learned commands on all
Components or all your macros or favorite channels
everywhere.
If you really want a fresh start, it is possible to reset
everything to the factory default settings.
Erasing Learned Buttons, Macros or Favorite Channels
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 seconds,
until the word "SETUP" is
displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don't press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
STEP 2:
Press the ERASE button on the
LCD screen.
STEP 3:
Press either the LEARN, MACRO
or FAV button. The following
screen appears:
ALL - Erases ALL of the specified
(Learned, Macro or FAV buttons
everywhere in the RF30)
DEVICE - Erases all learned or
Macro buttons in a single
Component (NOTE: This option
is not available for FAVs.)
KEY - Erases one button only.
38