Quick Set-Up - Universal Remote Control URC-SR3 Owner's Manual

Congratulations!
With your new URC-SR3 Remote Control,
you now have the power to control your
home entertainment system with just one
easy-to-use control. Thousands of audio and
video component codes have already been
programmed into the remote for you, making
it a breeze to set up. Be sure to install the
included batteries first. See page 6 for
instructions.
Set-up one component at a time, and
you'll move quickly through your system.
STEP 1: Turn on the component you want to
activate. (Other components can be on or
off, it doesn't matter.)
STEP 2: Point your new URC-SR3 Remote
Control toward the component and press the
appropriately labeled Component button (TV
for TV, DVD for DVD, etc.) While holding this
button down, press the numeric assigned to
your brand in the Quick Set-up Code Table
(See Page 2) and release both Component
button and the number key to save the code.
The component light will blink two times to
confirm that the code has been stored.
STEP 3: Point the remote control at the
component.
STEP 4: Press the power button. If it turns
off, it is programmed for your component. If
it does not turn off, use the Pre-Programmed
3-Digit code Method or Scanning Method.
Check your work before you move to
the next component. Press the POWER
[ON] button to turn the component back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for DVD).
Repeat Steps 1-3 to activate up to three
components.
Didn't work for one of your components?
See other set-up options on page 8.
Page | 1

Quick Set-up