Universal Remote Control URC-SR3 Owner's Manual page 14

Continue pressing the up or down button, in
approximately one second intervals, until the
component turns off. (DO NOT alternate
the up and down button. You want to move
in only one direction.)
STEP 4: Once the component has turned off,
check your work. Press the POWER [ON]
button to turn the component back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for DVD)
to make sure they all work. If the buttons do
not work properly, you need to find a new
code. Continue pressing the UP (or DOWN)
arrow button until you find a new code that
turns off the component and makes the
VOLUME or PLAY buttons respond correctly.
STEP 5: Save your work. Once you have
found the right code, you must save it. Press
the component button you just activated one
more time to save the code number. The
component light will blink three times to
confirm that the code was successfully stored.
Note: It may take up to five minutes to work
your way through the entire pre-programmed
table. If you cannot find the right code after
5 minutes of trying the Auto-Search Method,
try the Learning Method (page 14)
Page | 13