Setting Up The W660/W680 - Pitney Bowes W660 Operator's Manual

2 • Setting Up the W660/W680 Printer
Setting Up the
W660/W680
2-4
The assembled printer should look like the picture below. The
parts you have to put together are identified.
Wireframe
Input Stacker
Refer to this picture as you set up your printer. Follow the steps
on pages 2-7 through 2-15. The following product orientation
will be useful in performing these steps:
Front is the area of the printer housing the LCD.
Rear is the area of the printer with the cable interface panel.
Left side is the input area of the printer.
Right side is the output area of the printer.
Feed Ramp
and Lock Knob
Pitney Bowes W660/W680 Operator Guide
Sliding
Fence
Output Stacker