Communications - Pitney Bowes W660 Operator's Manual

Appendix A • Control Panel Menus
4. Lines Per
Address
(continued)

5. Communications

A-24
2. Press the Enter button to select this option.
3. The LCD displays "LINES/ADDRESS + (MORE) or –
(LESS)".
The range is from 1 to 66 lines. To select the range, press
the + button (MORE) or – button (LESS). The printer
can print an address which is typically between 3 and 8
lines.
4. Press the Menu button to back out of the menu until the
printer displays OFF LINE. Then, press the On Line
Button to enable the printer.
Transmitting data from the computer to the W660/W680 is by
way of the parallel interface or the serial interface. The printer
automatically senses the interface through which data is being
sent. When the computer uses the W660/W680's parallel inter-
face no communication settings are required.
When the serial interface is used, the W660/W680 Communica-
tions menu settings must be configured to match the computer
settings. Configure the computer to use either the XON/XOFF or
DTR handshaking settings to communicate with the W660/
W680. Use the following sub menus to change the W660/W680
serial communications. A. Baud Rate, B Parity, C. Word Length
and D. Line Termination.
NOTE: To verify that the computer and the W660/W680 are
communicating, with the printer on-line, type DIR>PRN
and press Enter.
Pitney Bowes W660/W680 Operator Guide