Adjust The Media Thickness Lever - Pitney Bowes W660 Operator's Manual

3 • W660/W680 Basics
Setting Up A
Job (continued)
3-14

7. Adjust the Media Thickness Lever

The media thickness lever sets the distance between the printhead
and the material. Use it to compensate for different material
thicknesses. The lever is located inside the printer under the
transport door, as shown below.
Set for approximate material thickness. Up position for thicker
material (.118"), down position for paper or card stock (.010").
Media Thickness
Lever
Print a test piece (page 3-16) with the lever in the middle posi-
tion. If the address appears blurred or too light, lower the lever; if
the address appears smeared, raise the lever
A Note about Print Quality
The W660/W680 is designed to feed and print on a range of
materials with various finishes and coatings. However, the
sharpness of the print may vary with different materials, depend-
ing on how absorbent the surface is, as well as other qualities.
You'll get best results using white wove bonded stock. Printing is
less sharp on Tyvek, recycled and glossy material. It is also
possible that ink may not dry thoroughly on certain very glossy
materials. Always test high gloss materials for their drying
qualities before you buy them in quantity and attempt to run a
print job.
Pitney Bowes W660/W680 Operator Guide