Assembling The W660/W680 - Pitney Bowes W660 Operator's Manual

2 • Setting Up the W660/W680 Printer
Important
Safety Notes
Assembling the
W660/W680
2-6
• Do not remove covers. The machine covers serve to
enclose hazardous parts. If the machine has been
dropped or has otherwise had the covers stressed in any
way, report it to your Pitney Bowes Customer Service
Representative.• Keep fingers, loose clothing, jewelry and
long hair away from the moving parts.
• To reduce the risk of fire and/or electrical shock, do not
attempt to disassemble this machine. If service is re-
quired, contact your Pitney Bowes Customer Service
Representative.
• Use only Pitney Bowes approved supplied ink cartridges
and cleaners. Read all instructions before attempting to
operate the equipment.
In addition, follow any specific occupational safety and health
standards for your workplace or area.
Once you've placed the printer in a suitable location, assemble
the printer components in the following order:
NOTE: Do not plug the printer into the power source until
you've completed steps 1-4.
1. Install the wireframe input stacker (page 2-7).
2. Install the sliding fence (page 2-8).
3. Position the output stacker (page 2-9).
4. Connect the parallel or serial cable (page 2-10).*
5. Attach the power cord and turn the printer ON (page
2-11).
6. Install the ink jet cartridges (page 2-13).
Instructions for installing each of these components start on
the next page.
* Requires use of a small flat-head screwdriver.
Pitney Bowes W660/W680 Operator Guide