Pitney Bowes W660 Operator's Manual page 109

6. Hex Dump Mode
(continued)
Pitney Bowes W660/W680 Operator Guide
Appendix A • Control Panel Menus
EXAMPLE:
The capital letter A is a HEX 41. Find the letter A on the above
chart, and look towards the top of the chart (MSB) and locate
the HEX number 4. Then look to the left side of the chart (LSB)
and locate the HEX number 1. Therefore the HEX number is
MSB=4 and LSB 1= 41.
This chart can be easily understood by memorizing five HEX
codes: Capital A is 41 Hex, numbers are 30's (0 is 30 HEX, 1 is
31 HEX etc.), Carriage Return (CR) is 0D, Line Feed (LF) is 0A
and Form Feed is 0C.
When HEX Mode is disabled, a typical address will be printed
on a single envelope. When Hex Mode is enabled, the same
address will be printed on several envelopes (3 to 5) because
HEX codes are two digits each separated by brackets. Since a
capital letter A is a Hex [41], there are 4 elements printed for
each character of the address.
When reviewing addresses printed in HEX mode, start from
the end of the address (ZIP Code 30's number) and count
backward toward the beginning of the address. Count the
number of CRs [0D] and LFs [0A]. Verify that the printer's
address setup has the same number of CRs and LFs as the
address printed. If there is a variation in the number of CRs or
LFs between addresses, then the address MUST be terminated
with a (form feed) FF [0C] (within the data sent to the
printer).
When you're finished using this option, use the Menu button
to back out of the menu until the printer displays OFF LINE.
Then press the On Line button and send addresses to the
printer.
A-27