Table of Contents
Advertisement
Power
Problems
Feeding
Problems
SV60970-OG Rev. A
DA900 AddressRight
Nothing happens when power is turned on. No LCD
display.
•
Check that power cord is plugged in.
•
Reconnect or reseat the cable from PC to printer.
Make sure clips are hooked, printer and screws are
seated, and computer is connected properly.
•
Turn printer OFF and then ON.
•
Plug a different device into the outlet you are us-
ing. If the outlet does not work, plug the printer
into a different outlet.
General
•
Static electricity is interfering with operation. Turn
the printer OFF and ON.
Intermittent feeds
•
Be sure to use the feed ramp. (See Chapter 3-Meet
the DA900.) The paper support adds a gentle slope
to the stack and helps feeding.
•
Check that the side guides are not too tight or too
far from media.
•
The feed rollers may be dirty. Clean the feed rollers
with water or alcohol wipes. DO NOT use any
other solvents or detergents. They could damage
the feed rollers.
•
Paper dust may be blocking the feed sensor. Clean
the sensor with compressed air.
•
The feed gap may be too tight or too loose. Adjust
the separator to the thickness of the material.
•
Your media may be too thin or too thick. Minimum
thickness is 0.004"; maximum is 0.375."
8
™
Printer
8-3
Advertisement
Table of Contents
