Applying A Privilege Level To A Username; Applying A Privilege Level To A Terminal Line; Configuring Logging - Dell S4048–ON Configuration Manual

exit
interface
line
linecard
Dell(conf)#interface ?
fastethernet
gigabitethernet
loopback
managementethernet
null
port-channel
range
sonet
tengigabitethernet
vlan
Dell(conf)#interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)#?
end
exit
Dell(conf-if-te-1/1)#exit
Dell(conf)#line ?
aux
console
vty
Dell(conf)#line vty 0
Dell(config-line-vty)#?
exit
Dell(config-line-vty)#
Dell(conf)#interface group ?
gigabitethernet
tengigabitethernet
vlan
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/1
Dell(conf-if-group-vl-1-2,te-1/1)# no shutdown
Dell(conf-if-group-vl-1-2,te-1/1)# end

Applying a Privilege Level to a Username

To set the user privilege level, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level

Applying a Privilege Level to a Terminal Line

To set a privilege level for a terminal line, use the following command.
• Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt is
hostname#, rather than hostname>.

Configuring Logging

The Dell Networking OS tracks changes in the system using event and error messages.
By default, Dell Networking OS logs these messages on:
Exit from configuration mode
Select an interface to configure
Configure a terminal line
Set line card type
Fast Ethernet interface
Gigabit Ethernet interface
Loopback interface
Management Ethernet interface
Null interface
Port-channel interface
Configure interface range
SONET interface
TenGigabit Ethernet interface
VLAN interface
Exit from configuration mode
Exit from interface configuration mode
Auxiliary line
Primary terminal line
Virtual terminal
Exit from line configuration mode
GigabitEthernet interface IEEE 802.3z
TenGigabit Ethernet interface
VLAN keyword
Management 65