Configuring A Custom-Defined Period For Ntp Time Synchronization; Dell Networking Os Time And Date; Configuration Task List; Setting The Time And Date For The Switch Software Clock - Dell S4048–ON Configuration Manual
Hide thumbs
Also See for S4048–ON:
- Configuration manual (1039 pages) ,
- Deployment manual (78 pages) ,
- Troubleshooting manual (29 pages)
Table of Contents
Advertisement
Configuring a Custom-defined Period for NTP time
Synchronization
You can configure the system to send an audit log message to a syslog server if the time difference from the NTP server is greater than a
threshold value (offset-threshold). However, time synchronization still occurs. To configure the offset-threshold, follow this procedure.
•
Specify the threshold time interval before which the system generates an NTP audit log message if the system time deviates from the
NTP server.
CONFIGURATION mode
ntp offset-threshold threshold-value
The range for threshold-value is from 0 to 999.
Dell(conf)#ntp offset-threshold 9
Dell Networking OS Time and Date
You can set the time and date using the Dell Networking OS CLI.
Configuration Task List
The following is a configuration task list for configuring the time and date settings.
•
Setting the Time and Date for the Switch Software Clock
•
Setting the Timezone
•
Setting Daylight Saving Time Once
•
Setting Recurring Daylight Saving Time
Setting the Time and Date for the Switch Software Clock
You can change the order of the month and day parameters to enter the time and date as time day month year. You cannot delete the
software clock.
The software clock runs only when the software is up. The clock restarts, based on the hardware clock, when the switch reboots.
To set the software clock, use the following command.
•
Set the system software clock to the current time and date.
EXEC Privilege mode
clock set time month day year
•
time: enter the time in hours:minutes:seconds. For the hour variable, use the 24-hour format; for example, 17:15:00 is 5:15 pm.
•
month: enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to
time day month year.
•
day: enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display
to time day month year.
•
year: enter a four-digit number as the year. The range is from 1993 to 2035.
Example of the clock set Command
Dell#clock set 16:20:00 19 september 2009
Dell#
System Time and Date
951
Advertisement
Table of Contents
Troubleshooting
