Dell S4048–ON Configuration Manual page 61

Hide thumbs Also See for S4048–ON:

Table of Contents

However, these changes are backward-compatible and do not affect existing behavior; meaning, you can still use the ip http source-

interface command to communicate with a particular interface even if no VRF is configured on that interface

If the HTTP service is not VRF-aware, then it uses the global routing table to perform the look-up.

To enable an HTTP client to look up the VRF table corresponding to either management VRF or any nondefault VRF, use the ip http

vrf command in CONFIGURATION mode.

Configure an HTTP client with a VRF that is used to connect to the HTTP server.

CONFIGURATION MODE

Dell(conf)#ip http vrf {management | <vrf-name>}

Getting Started

Troubleshooting