Enabling The Fcoe Transit Feature - Dell S4048–ON Configuration Manual

• You can configure multiple FCF-trusted interfaces in a VLAN.
• When you disable FIP snooping:
• ACLs are not installed, FIP and FCoE traffic is not blocked, and FIP packets are not processed.
• The existing per-VLAN and FIP snooping configuration is stored. The configuration is re-applied the next time you enable the FIP
snooping feature.
• You must apply the CAM-ACL space for the FCoE region before enabling the FIP-Snooping feature. If you do not apply CAM-ACL
space, the following error message is displayed:
Dell(conf)#feature fip-snooping
% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.
Dell(conf)#
NOTE: Manually add the CAM-ACL space to the FCoE region as it is not applied by default.
To support FIP-Snooping and set CAM-ACL, usecam-acl l2acl 4 ipv4acl 4 ipv6acl 0 ipv4qos 2 l2qos 1 l2pt 0
ipmacacl 0 vman-qos 0 ecfmacl 0 fcoeacl 2 command.
CAM ACL Table
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Ipv4Qos :
L2Qos :
L2PT :
IpMacAcl :
VmanQos :
VmanDualQos :
EcfmAcl :
FcoeAcl :
iscsiOptAcl :
ipv4pbr :
vrfv4Acl :
Openflow :
fedgovacl :
nlbclusteracl:
st-sjc-s5000-29#

Enabling the FCoE Transit Feature

The following sections describe how to enable FCoE transit.
NOTE: FCoE transit is disabled by default. To enable this feature, you must follow the
Snooping.
As soon as you enable the FCoE transit feature on a switch-bridge, existing VLAN-specific and FIP snooping configurations are applied.
The FCoE database is populated when the switch connects to a converged network adapter (CNA) or FCF port and compatible DCB
configurations are synchronized. By default, all FCoE and FIP frames are dropped unless specifically permitted by existing FIP snooping-
generated ACLs. You can reconfigure any of the FIP snooping settings.
If you disable FCoE transit, FIP and FCoE traffic are handled as normal Ethernet frames and no FIP snooping ACLs are generated. The
VLAN-specific and FIP snooping configuration is disabled and stored until you re-enable FCoE transit and the configurations are re-applied.
1 block = 128 entries
4
4
0
2
1
0
0
0
0
0
2
0
0
0
0
0
0
Configure FIP
FIP Snooping 327