Obtaining A Value For Mib Objects - Dell S4048–ON Configuration Manual

MIB Object
copyTimeStarted
copyTimeCompleted
copyFailCause
copyEntryRowStatus

Obtaining a Value for MIB Objects

To obtain a value for any of the MIB objects, use the following command.
• Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index | mib-
object.index]
index: the index value used in the snmpset command used to complete the copy operation.
NOTE: You can use the entire OID rather than the object name. Use the form: OID.index.
Examples of Getting MIB Object Values
The following examples show the snmpget command to obtain a MIB object value. These examples assume that:
• the server OS is UNIX
• you are using SNMP version 2c
• the community name is public
• the file f10-copy-config.mib is in the current directory
NOTE: In UNIX, enter the snmpset command for help using this command.
The following examples show the command syntax using MIB object names and the same command using the object OIDs. In both cases,
the same index number used in the snmpset command follows the object.
OID
.1.3.6.1.4.1.6027.3.5.1.1.1.1.12
.1.3.6.1.4.1.6027.3.5.1.1.1.1.13
.1.3.6.1.4.1.6027.3.5.1.1.1.1.14
.1.3.6.1.4.1.6027.3.5.1.1.1.1.15
Values
3 = failed
Time value
Time value
1 = bad filename
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Row status
Simple Network Management Protocol (SNMP)
Description
Specifies the point in the up-
time clock that the copy
operation started.
Specifies the point in the up-
time clock that the copy
operation completed.
Specifies the reason the copy
request failed.
Specifies the state of the copy
operation. Uses CreateAndGo
when you are performing the
copy. The state is set to active
when the copy is completed.
875