Frrp Support On Vlt - Dell S4048–ON Configuration Manual

no shutdown
!
interface Vlan 101
no ip address
tagged TenGigabitEthernet 2/14,31
no shutdown
!
interface Vlan 201
no ip address
tagged TenGigabitEthernet 2/14,31
no shutdown
!
protocol frrp 101
interface primary TenGigabitEthernet 2/14 secondary TenGigabitEthernet 2/31 control-vlan 101
member-vlan 201
mode transit
no disable
Example of R3 TRANSIT
interface TenGigabitEthernet 3/14
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 3/21
no ip address
switchport
no shutdown
!
interface Vlan 101
no ip address
tagged TenGigabitEthernet 3/14,21
no shutdown
!
interface Vlan 201
no ip address
tagged TenGigabitEthernet 3/14,21
no shutdown
!
protocol frrp 101
interface primary TenGigabitEthernet 3/21
secondary TenGigabitEthernet 3/14 control-vlan 101
member-vlan 201
mode transit
no disable

FRRP Support on VLT

Using FRRP rings, you can inter-connect VLT domains across data centers.
These FRRP rings make use of Layer2 VLANs that spawn across Data Centers and provide resiliency by detecting node or link level failures.
You can configure a simple FRRP ring that connects a VLT device in one data center to a VLT devices in two or more Data Centers.
NOTE: This configuration connects VLT devices across Data Centers using FRRP; however, the VLTi may or may not participate
as a ring interface of any FRRP ring.
Following figure shows a simple FRRP ring inter-connecting VLT device:
356 Force10 Resilient Ring Protocol (FRRP)