Dell S4048–ON Configuration Manual page 908

Hide thumbs Also See for S4048–ON:

Table of Contents

Assign a stack group to each unit.

CONFIGURATION mode

stack-unitstack-unit-number stack-group stack-group-number

Connect the new unit to the stack using stacking cables.

Example of Adding a Stack Unit with a Conflicting Stack Number (Before and After)

The following example shows adding a stack unit with a conflicting stack number (before).

Dell#show system brief

Stack MAC : 00:01:e8:8a:df:e6

Reload Type : normal-reload

-- Stack Info --

Unit UnitType

----------------------------------------------------------------

The following example shows adding a stack unit with a conflicting stack number (after).

Dell#show system brief

Stack MAC : 00:01:e8:8a:df:e6

Reload Type : normal-reload

-- Stack Info --

Unit UnitType

----------------------------------------------------------------

Adding a Configured Unit to an Existing Stack

To add a configured unit to an existing stack, use the following commands.

If a stack unit goes down and is removed from the stack, the logical provisioning configured for that stack-unit number is saved on the

master and standby units. When a new unit is added to the stack, if a stack group configuration conflict occurs between the new unit and

the provisioned stack unit, the configuration of the new unit takes precedence.

Add the configured unit to the top or bottom of the stack.

Power on the switch.

Attach cables to connect ports on the added switch to one or more existing switches in the stack.

Log on to the CLI and enter global configuration mode.

Password: *****

Dell> enable

Dell# configure

Configure the ports on the added switch for stacking.

Version Ports

Troubleshooting