Applying A Routing Policy To Ipv6 Route Redistribution - HP MSR2000 series Configuration Manual

# Configure IP prefix list prefix-a to permit route 172.17.1.0/24.
[SwitchB] ip ip-prefix prefix-a index 10 permit 172.17.1.0 24
Configure a routing policy.
5.
[SwitchB] route-policy isis2ospf permit node 10
[SwitchB-route-policy] if-match ip-prefix prefix-a
[SwitchB-route-policy] apply cost 100
[SwitchB-route-policy] quit
[SwitchB] route-policy isis2ospf permit node 20
[SwitchB-route-policy] if-match acl 2002
[SwitchB-route-policy] apply tag 20
[SwitchB-route-policy] quit
[SwitchB] route-policy isis2ospf permit node 30
[SwitchB-route-policy] quit
Apply the routing policy to route redistribution:
6.
# On Switch B, apply the routing policy when redistributing routes.
[SwitchB] ospf
[SwitchB-ospf-1] import-route isis 1 route-policy isis2ospf
[SwitchB-ospf-1] quit
# Display the OSPF routing table on Switch A. The cost of route 172.17.1.0/24 is 100, the tag
of route 172.17.1.0/24 is 20.
[SwitchA] display ospf routing
Routing for Network
Destination
192.168.1.0/24
Routing for ASEs
Destination
172.17.1.0/24
172.17.2.0/24
172.17.3.0/24
192.168.2.0/24
Total Nets: 5
Intra Area: 1

Applying a routing policy to IPv6 route redistribution

Network requirements
As shown in
Enable RIPng on Switch A and Switch B.
•
On Switch A, configure three static routes, and apply a routing policy to static route redistribution
•
to permit routes 20::0/32 and 40::0/32, and deny route 30::0/32.
Display RIPng routing table information on Switch B to verify the configuration.
•
OSPF Process 1 with Router ID 192.168.1.1
Routing Tables
Cost
1
Cost
100
1
1
1
Inter Area: 0
Figure 121:
Type NextHop
Transit 192.168.1.1
Type Tag
Type2 1
Type2 20
Type2 1
Type2 1
ASE: 4 NSSA: 0
370
AdvRouter Area
192.168.1.1
NextHop AdvRouter
192.168.1.2 192.168.2.2
192.168.1.2 192.168.2.2
192.168.1.2 192.168.2.2
192.168.1.2 192.168.2.2
0.0.0.0