HP MSR2000 series Configuration Manual page 32

<SwitchC> system-view
[SwitchC] ip route-static 120.1.1.0 24 vlan-interface 13 13.1.1.1
[SwitchC] ip route-static 121.1.1.0 24 vlan-interface 11 10.1.1.102
# Configure static routes on Switch D.
<SwitchD> system-view
[SwitchD] ip route-static 120.1.1.0 24 vlan-interface 12 11.1.1.1
[SwitchD] ip route-static 121.1.1.0 24 vlan-interface 10 12.1.1.1
Verify the configuration:
3.
# Display the BFD session information on Switch A.
<SwitchA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD
4/7
The output shows that the BFD session has been created.
# Display static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 1
Destination/Mask
120.1.1.0/24
The output shows that Switch A communicates with Switch B through VLAN-interface 10.
When the link over VLAN-interface 10 fails, Switch A can quickly detect the failure.
# Display static routes on Switch A again.
<SwitchA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11 now.
Init Mode: Active
SourceAddr DestAddr
1.1.1.9 2.2.2.9
Proto Pre Cost
Static 60 0
Proto Pre Cost
Static 65 0
Proto Pre Cost
Static 65 0
19
State Holdtime Interface
Up 2000ms Loop1
NextHop Interface
2.2.2.9 Vlan10
NextHop Interface
10.1.1.100 Vlan11
NextHop Interface
10.1.1.100 Vlan11