Configuring Interface Pbr Based On Packet Type - HP MSR2000 series Configuration Manual

[SwitchA-Vlan-interface20] ip address 1.1.3.1 255.255.255.0
Configure Switch B:
2.
# Configure the IP address of VLAN-interface 10.
<SwitchB> system-view
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ip address 1.1.2.2 255.255.255.0
[SwitchB-Vlan-interface10] quit
Configure Switch C:
3.
# Configure the IP address of VLAN-interface 20.
<SwitchC> system-view
[SwitchC] interface vlan-interface 20
[SwitchC-Vlan-interface20] ip address 1.1.3.2 255.255.255.0
[SwitchC-Vlan-interface20] quit
Verify the configuration:
4.
# Telnet to Switch B (1.1.2.2/24) from Switch A. The operation succeeds.
# Telnet to Switch C (1.1.3.2/24) from Switch A. The operation fails.
<SwitchA> telnet 1.1.3.2
Trying 1.1.3.2 ...
Press CTRL+K to abort
Can't connect to the remote host!
# Ping Switch C (1.1.3.2/24) from Switch A. The operation succeeds.
<SwitchA> ping 1.1.3.2
PING 1.1.3.2: 56
Reply from 1.1.3.2: bytes=56 Sequence=1 ttl=255 time=2 ms
Reply from 1.1.3.2: bytes=56 Sequence=2 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=3 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=4 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=5 ttl=255 time=1 ms
--- 1.1.3.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/2 ms
Telnet uses TCP, and ping uses ICMP. The preceding results show that all TCP packets of Switch A
are forwarded to next hop 1.1.2.2, and other packets are forwarded via VLAN-interface 20. The
PBR configuration is effective.

Configuring interface PBR based on packet type

Network requirements
As shown in
are forwarded to next hop 1.1.2.2 and other packets are forwarded according to the routing table.
data bytes, press CTRL_C to break
Figure 124, configure PBR on Switch A, so that TCP packets arriving on VLAN-interface 1 1
384