HP MSR2000 series Configuration Manual page 418

Step
3. Disable routing loop
detection.
4. Configure the OSPF
domain ID.
5. Redistribute the VPN
routes.
6. Configure a filtering policy
to filter advertised routes.
7. Configure the default
parameters for
redistributed routes (cost,
route number, tag, and
type).
8. Create an OSPF area and
enter OSPF area view.
9. Enable OSPF on the
interface attached to the
specified network in the
area.
Configuring IS-IS between MCE and PE
Step
1. Enter system view.
2. Create an IS-IS process
for a VPN instance and
enter IS-IS view.
3. Configure a network
entity title.
4. Redistribute the VPN
routes.
Command
vpn-instance-capability simple
domain-id domain-id [ secondary ]
import-route protocol [ process-id |
allow-ibgp ] [ cost cost | type type |
tag tag | route-policy
route-policy-name ] *
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] ]
default { cost cost | limit limit | tag
tag | type type } *
area area-id
network ip-address wildcard-mask
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
import-route { isis [ process-id ] | ospf
[ process-id ] | rip [ process-id ] | bgp
[ allow-ibgp ] | direct | static } [ cost cost
| cost-type { external | internal } |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
405
Remarks
Disabled by default.
You must disable routing loop
detection for a VPN OSPF process on
the MCE. Otherwise, the MCE
cannot receive OSPF routes from the
PE.
Optional.
0 by default.
By default, no route of any other
routing protocol is redistributed into
OSPF.
Optional.
By default, advertised routes are not
filtered.
Optional.
The default cost is 1, the default
maximum number of routes
redistributed per time is 1000, the
default tag is 1, and default type of
redistributed routes is Type-2.
By default, no OSPF area is created.
By default, an interface neither
belongs to any area nor runs OSPF.
Remarks
N/A
N/A
Not configured by default.
Optional.
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.