Disabling Host Route Reception - HP MSR2000 series Configuration Manual

Enabling RIPv2 route automatic summarization
You can disable RIPv2 route automatic summarization if you want to advertise all subnet routes.
To enable RIPv2 route automatic summarization:
Step
1. Enter system view.
2. Enter RIP view.
3. Enable RIPv2 automatic route
summarization.
Advertising a summary route
Disable RIPv2 route automatic summarization before advertising a summary route on an interface.
To configure RIPv2 to advertise a summary route on the specified interface:
Step
1. Enter system view.
2. Enter RIP view.
3. Disable RIPv2 automatic route
summarization.
4. Return to system view.
5. Enter interface view.
6. Advertise a summary route.

Disabling host route reception

Perform this task to disable RIPv2 from receiving host routes from the same network and save network
resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Step
1. Enter system view.
2. Enter RIP view.
3. Disable RIP from receiving
host routes.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
summary
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
undo summary
quit
interface interface-type
interface-number
rip summary-address ip-address
{ mask | mask-length }
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
undo host-route
28
Remarks
N/A
N/A
Optional.
Enabled by default.
If the subnet routes in the routing
table are not consecutive, disable
automatic route summarization to
avoid black hole routing.
Remarks
N/A
N/A
Enabled by default.
N/A
N/A
N/A
Remarks
N/A
N/A
Enabled by default.