Configuring Ospfv3 Route Redistribution - HP MSR2000 series Configuration Manual

----------------------------------------------------------------------
Neighbor ID
1.1.1.1
2.2.2.2
3.3.3.3
Restart DR and BDR election:
4.
# Use the shutdown and undo shutdown commands on interfaces to restart DR and BDR election.
(Details not shown.)
# Display neighbor information on Switch A. Switch C becomes the BDR.
[SwitchA] display ospfv3 peer
----------------------------------------------------------------------
Neighbor ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D. Switch A becomes the DR.
[SwitchD] display ospfv3 peer
----------------------------------------------------------------------
Neighbor ID
1.1.1.1
2.2.2.2
3.3.3.3

Configuring OSPFv3 route redistribution

Network requirements
As shown in
• Switch A, Switch B, and Switch C are in Area 2.
OSPFv3 process 1 and OSPFv3 process 2 are enabled on Switch B. Switch B communicates with
•
Switch A and Switch C through OSPFv3 process 1 and OSPFv3 process 2.
Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process 1 on
Switch B and set the default metric for redistributed routes to 3. Then, Switch C can learn the routes
destined for 1::0/64 and 2::0/64, and Switch A cannot learn the routes destined for 3::0/64 or
4::0/64.
OSPFv3 Area ID 0.0.0.0 (Process 1)
Pri State
100 Full/DROther
0 Full/DROther
2 Full/Backup
OSPFv3 Area ID 0.0.0.0 (Process 1)
Pri State
0 Full/DROther
2 Full/Backup
1 Full/DROther
OSPFv3 Area ID 0.0.0.0 (Process 1)
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/Backup
Figure 108:
Dead Time Interface
00:00:33 Vlan100
00:00:36 Vlan200
00:00:40 Vlan100
Dead Time Interface
00:00:31 Vlan200
00:00:39 Vlan100
00:00:37 Vlan200
Dead Time Interface
00:00:34 Vlan100
00:00:34 Vlan200
00:00:32 Vlan100
297
Instance ID
0
0
0
Instance ID
0
0
0
Instance ID
0
0
0