Configuring Ipv6 Bgp Basic Functions; Configuration Prerequisites; Configuration Guidelines; Specifying An Ipv6 Bgp Peer - HP MSR2000 series Configuration Manual

Task
Configuring BFD for IPv6 BGP

Configuring IPv6 BGP basic functions

Configuration prerequisites

Before you configure IPv6 BGP basic functions, complete the following tasks:
Specify IP addresses for interfaces.
•
Enable IPv6 with the ipv6 command in system view.
•

Configuration guidelines

Create a peer group before configuring basic functions for it. For more information, see
IPv6 BGP peer

Specifying an IPv6 BGP peer

Step
1. Enter system view.
2. Enter BGP view.
3. Specify a router ID.
4. Enter IPv6 address family
view.
5. Specify an IPv6 peer.

Injecting a local IPv6 route

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Inject a local route into the
IPv6 BGP routing table.
group."
Command
system-view
bgp as-number
router-id router-id
ipv6-family
peer ipv6-address as-number
as-number
Command
system-view
bgp as-number
ipv6-family
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
325
Remarks
Optional
"Configuring
Remarks
N/A
N/A
Optional.
Required if no IP addresses are
configured for any interfaces.
N/A
N/A
Remarks
N/A
N/A
N/A
Not added by default.