HP MSR2000 series Configuration Manual page 435

Step
4. Configure the default cost
value for the redistributed
routes.
5. Return to system view.
6. Enter interface view.
7. Enable RIPng on the interface.
Configuring OSPFv3 between IPv6 MCE and VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of
different IPv6 VPNs to be exchanged between the IPv6 MCE and the sites through different OSPFv3
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between IPv6 MCE and VPN site:
Step
1. Enter system view.
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
3. Set the router ID.
4. Redistribute remote site routes
advertised by the PE..
5. Return to system view.
6. Enter interface view.
7. Enable OSPFv3 on the
interface.
NOTE:
Deleting a VPN instance also deletes all related OSPFv3 processes at the same time.
Configuring IPv6 IS-IS between IPv6 MCE and VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an IPv6
IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public network.
Command
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
422
Remarks
Optional.
0 by default.
N/A
N/A
Disabled by default.
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal OSPFv3.
N/A
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.