Installation Completed; Optional Extras; Outside Air Connection - Jøtul FS 74 Installation Instructions Manual

5.0 Installation completed

Refer to the "Installation manual with technical data" for the Jøtul
I 520 (cat. no. 10044945) for use and maintenance of the product!
NB: The new surround may have some small scratches being
visible through the base coat. They are only superficial and do not
impair the quality of the product. These scratches will be covered
when the surround is beeing painted after the installation.
5.1 Painting
After installation, wait until the following day before painting.
Use water-based paint. If you want to create some surface texture,
mix some tile cement into the paint.
5.2 Minor damage
Once the insert has been installed, any nicks or irregularities in
the concrete should be filled using the cement filler included in
the kit.
• In order to achieve the best result the surround should
be rubbed down with fine sandpaper, smoothing any
unevenness or sharp edges prior to painting.
• Then apply one coat.
• Mix the powder (cement filler) with water to form a smooth
paste (like toothpaste).
• Smooth away any unevenness, allow to dry and then rub
down with fine sandpaper.
• If the hole is deep, we recommend applying the filler in two
stages to prevent it sinking.
• Apply a second coat of the desired colour.
5.3 Cracks
In some instances, small cracks may appear at the joints after a
few months' use due to settling of the building. These cracks can
be easily repaired:
Open up the crack with a tool, e.g. a screwdriver, to create more
room for the grouting cement.
First remove any dust using a vacuum cleaner. Then inject some
acrylic grout, and smooth it off using a wet, soapy fingertip.
After 48 hours, the joint can be repainted.

6.0 Optional extras

Floor plate in front of the product
Cat. no. 51046302
Adapter for air supply
Cat. no. 51046710

Outside air connection

21046789
Cat. no.
ENGLISH
45