Engineering Steps - Siemens SIMODRIVE 611 digital Configuration Manual

Aotewell Ltd
05.01 05.08
1.2
Procedure
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
HongKong|UK|China
www.aotewell.com

Engineering steps

Note
Depending on the result of a hazard analysis/risk assessment to be performed
according to the Machinery Directive 98/37/EC and EN 292–1, EN 954–1,
EN ISO 13849–1 and EN 1050, the machinery construction company must
configure, for all its machine types and versions, the safety–relevant control
sections for the complete machine, incorporating all of the integrated
components. These also include the electric drives.
Note
When engineering SIMODRIVE 611, it is assumed that the motors to be used
are known.
Reference: refer to the appropriate references for motors in the Appendix
A SIMODRIVE drive group is configured in two phases:
S
Phase 1
S
Phase 2
Note
A selection guide is available for engineering the 6SN series, e.g.:
S
NCSD Configurator
For additional information, please contact your local Siemens office.
The functions of SIMODRIVE control units are described with keywords in this
Configuration Manual. Limit values may be specified in some cases. For
additional details, please refer to the appropriate documentation.
Detailed ordering information and instructions are provided in Catalogs NC 60
and NC Z.
sales@aotewell.com
1 Overview of the Drive System
Selecting the components
Connection configuration
Industry Automation
1.2 Engineering steps
(refer to Fig. 1-4)
(refer to Fig. 1-5)
1-27
+86-755-8660-6182
1