Mounting And Installing The Modules - Siemens SIMODRIVE 611 digital Configuration Manual

Aotewell Ltd
05.01 05.08
2.1.2
Drive bus
Equipment bus
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
HongKong|UK|China
www.aotewell.com

Mounting and installing the modules

When mounting and installing the SIMODRIVE modules on the rear cabinet
panel, proceed in the following sequence:
1. Screw–in the retaining screws up to a clearance of approx. 4 mm from the
surface of the mounting panel.
2. Locate the modules in the screws and then tighten the screws with 6 Nm.
3. Locate the DC link connecting bar in the adjacent module under the screws
provided and tighten these screws with 1.8 Nm –0/+30%.
The DC link covers must only be installed with the power turned off. Check the
spring elements for exact positioning prior to installation. Covers with warped
spring elements must be replaced.
For drives with a digital setpoint interface, a drive bus cable is required for the
control and communications interface SINUMERIK 840D powerline (refer to
Fig. 2-1).
Table 2-1
Designation
for module width
S
50 mm
S
100 mm
S
150 mm
S
300 mm
In order to jumper monitoring/pulsed
resistor modules, select the drive bus
cable to be 50 mm longer!
S
350 mm round long cable
S
200 mm long ribbon cable
The electronics power supply between the individual modules is established
using the equipment bus cable (refer to Fig. 2-1). The equipment bus cable is
included in the scope of supply of the power module.
sales@aotewell.com
2.1 Arrangement of the modules and their mounting
Order number assignment
6SN11 61–1CA00–0AAj
6SN11 61–1CA00–0BAj
6SN11 61–1CA00–0CAj
6SN11 61–1CA00–0DA0
j ––> 0: Ribbon cable
j ––> 1: Round cable (control units required
from six axes onwards)
6SN11 61–1CA00–0EA1
6SN11 61–1CA00–0FA0
Industry Automation
2 System Configuration
Order number (MLFB)
2-45
+86-755-8660-6182
2