Electrical connections in the control panel
Note
In the delivered condition, the coding
card is affixed inside the control
panel. Remove the coding card and
insert into the control unit; see
page 80.
Overview of electrical connections in the control panel
A Transformer
B Fan control (230 V~)
C Sensor terminal strip (LV ≤ 42 V~)
D Refrigerant circuit control (con-
troller for electronic expansion
valve EEV)
E Plug rail
Installation sequence
(cont.)
F Only type AWC-I-M:
Control module, instantaneous
heating water heater (accessory)
Type AW-O-M:
The control module for the instan-
taneous heating water heater is
installed on the wall inside the
building adjacent to the instanta-
neous heating water heater (see
separate installation instructions).
G Mains terminals (230 V~) for the
compressor and fan with contact
shield and power-OFF seal if
required
65