Expansion Board - HP Apollo 2000 System Maintenance And Service Manual

4. Remove the existing front support bracket from the accelerator. Keep this bracket to install it onto the failed
accelerator.
• AMD FirePro S9150 GPU or AMD FirePro S7150 GPU
5. Install the front and rear support brackets for Accelerator 2 onto the new accelerator:
a. Install the front support bracket for Accelerator 2.
b. If replacing an AMD FirePro S9150 GPU or AMD FirePro S7150 GPU, reinstall the cover.
c. Install the rear support bracket for Accelerator 2.
To replace the component, reverse the removal procedure.

Expansion board

About this task
Expansion boards supported with this server include any board installed in the PCIe riser cage assembly,
including controllers, NIC cards, and accelerators.
For GPU accelerator removal and replacement procedures, see the following:
• Replacing Accelerator 1 in the FlexibleLOM 2U node riser cage assembly
• Replacing Accelerator 2 in the three-slot riser cage assembly
• Replacing Accelerator 1 in the three-slot riser cage assembly
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
To remove the component:
108 Expansion board