For a redundant power supply configuration
o
For a redundant power supply configuration showing Smart Array controller card installed
o
To replace the component, reverse the removal procedure.
Full-length expansion board
To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the front bezel (on page 25).
3.
Place the server on its side.
4.
Remove the access panel
5.
("Access
panel" on page 26).
Removal and replacement procedures 40