Console Management
Spanning Tree Protocol Group Configuration
Figure 5.26 Spanning Tree Protocol Control/Status Menu
This menu allows you to monitor and configure the switch's STP
system. The switch uses one STP system with a single MAC address.
The settings are defined as:
•
STP Specification Read only. States the IEEE STP
specification used.
•
STP Base MAC Address Read only. States the MAC
address used by STP to identify the switch.
•
STP Topology Change Count Read only. States the
number of changes in the network topology since the last
switch reset or initialization.
•
STP Time Since Topology Changed Read only. States
the time elapsed since the last network topology change.
•
STP Designated Root Read only. States the root bridge's
bridge identifier.
•
STP Root Port Read only. States the switch's root port.
5-33